Welcome to HandloadersBench.com. You will receive a activation email with a link in it to activate your account. If you don't receive the email check your spam or junk folders. Email servers look at our email as spam. Our mission here is to provide a place for those interested in the hobby of Reloading Ammunition. We offer a series of forums where they can ask questions, share answers, and highlight successes & failures so that others can learn. If you join our site please be aware that front porch rules apply. If you wouldn't say it on your front porch with grandma, your pastor and your 12 year old niece present it doesn't belong here. The Golden Rule applies. If you can live within those guidelines, Welcome Aboard!
Spammers, trolls, and flamers will not last long here, your time would be better spent looking for a board where those traits are acceptable. HB Administration
I am new to all of this magazine stuff for AR's
Thanks RobertMT that should do the trick.
I looked up the magazine I was using that a buddy gave me It is an Adventure Line and I do not think I will cut it.
Then researching I found out it is aluminum.
Thought it was thin steel.
Not going to turn out well cutting and bending aluminum.
But I could anneal it and it would bend without breaking.
But not going there.
Deer season rolls around I thought I could take a 10 round magazine and add 2 pop rivets to the sides to keep the follower from going down too far.. I like the cut out picture thanks for that.